Wednesday, July 1, 2009

Ultrasonic Parking Sonar by 4017



It works on the sonar principle, sending an ultrasound burst and listening for first echo. The burst generated by the oscillator built around U4D (you must set the frequency using TR2 to have 40 kHz or the maximum sensitivity), U4E buffers the output and U4F boost the signal doubling the voltage span across the TX piezo transducer .

A new burst is generated each time the decade counter (4017 in the circuit diagram) is in its reset state, that is output 0 is selected. The other outputs (1 to 9) are scanned sequentially following burst generation, until an echo strikes back the RX receiver. It is then amplified by the transistor input stage, triggering the monostable built around U4A - U4B. The monostable stops temporarly the scanning, and a led corresponding to the obstacle distance appears as continuously lit. The buzzer bleeps when the first led (minimum distance) il lit.

To set up:

Set TR2 for maximum sensitivity (usually 40 kHz for most commercially available ultrasonic transducer pairs).
Set TR1 for your preferred range. Setting it to minimum resistance shortens the distance for each led (minimum range). I suggest a range of 90 cm (10 cm each led).

Hints:

First of all, be careful not to exchange the ultrasonic transmitter with the receiver: they look very similar, and I suggest you to mark them very clearly from the moment you buy them.
During setup, place the ultrasonic transducers over a soft surface, near the border of a table, 10 cm apart of each other pointing outwards the table. Then adjust TR1 and TR2 using a rigid surface (for example a metal sheet) placed in front of sensors, at a variable distance.


Link : http://www.uashem.com/pageid-419.html

No comments:

Post a Comment